Installation Guide

Every TheWheelGuy steering wheel is plug-and-play and comes with the airbag included. Most customers fit it themselves at home in under an hour with basic hand tools. If you're not confident working around an airbag, any auto electrician or mechanic can fit it for you quickly.

Before you start

  • Check the fitment table on the product page, or text us your model and year on 0410 956 690 to double-check.
  • Tools you'll usually need: a socket set (commonly a Torx/triple-square bit and a socket for the centre bolt), a flat-head screwdriver or trim tool, and a torque wrench.
  • Park on level ground with the front wheels pointing straight ahead.

Step-by-step

  1. Disconnect the battery. Remove the negative (–) terminal, then wait the time stated in your vehicle's owner's manual (usually several minutes) so the airbag system fully powers down. Never skip this step.
  2. Remove the factory airbag. Release the airbag from the back or sides of the wheel (release points or bolts vary by model), lift it out gently and unplug its connectors. Place it face-up somewhere safe, away from where you're working.
  3. Unplug the wheel's wiring. Disconnect any remaining plugs for the wheel buttons and paddle shifters.
  4. Mark and remove the centre bolt. With the wheel straight, mark the wheel and steering column with a paint pen or tape so you can line up the new wheel exactly. Undo the centre bolt and pull the old wheel off the spline.
  5. Fit your new wheel. Feed the wiring through, slide the new wheel onto the spline lined up with your mark, and make sure it sits straight.
  6. Tighten the centre bolt to the torque specified by your vehicle manufacturer. Use a new bolt if your manufacturer specifies one.
  7. Reconnect everything. Plug in the button and paddle connectors, then the airbag connectors until they click, and fit the airbag into the new wheel.
  8. Reconnect the battery and check. Turn the ignition on and make sure the airbag warning light goes out after the self-test. Test the buttons, horn and paddles before driving.

Does my car need coding?

Some newer models may need the new wheel coded for extras like heating or LED shift lights to work. Text us your model and year before you buy and we'll tell you exactly what's needed.

Need help?

Text or call 0410 956 690 or email thewheelguy0@gmail.com. Send a photo of where you're up to and we'll walk you through it.

Safety note: airbags are safety devices. This guide is general information only. Always follow your vehicle manufacturer's procedures, and if you're unsure at any point, have a qualified mechanic or auto electrician do the install. If the airbag warning light stays on, don't drive the car until it's been checked.